The EP Greenhouse gear driver is a concise and lightweight reduction gear motor with a limit switch system that is suitable for assembly of a locally available electric engine. The gear motor is used in manually-controlled or climate-managed ventilation and screen systems in greenhouses. The quick and easy-to-install EP geared motor is usually rainproof and windproof. The gearbox has a high protection class (IP65) and can be utilized in an ambient temperature of 0-60 °C.
The low-noise gear driver for Greenhouse includes a gearwheel transmission and a worm wheel transmission, which are integrated in an aluminum precision housing. The self-braking worm wheel transmission means that the drive shaft is usually locked when the reduction gear reducer isn’t running. The fully sealed reduction gearbox has an growth chamber with a diaphragm to keep carefully the gear essential oil at a minimal pressure under all conditions, even at high temperatures. Thanks to the use of an expansion chamber, the gear motor could be installed in any position. There are no restrictions, because there is no dependence on a bleed connect. The sealed reduction geared motor keeps the gear essential oil of the reducer in optimum condition because of its entire operating lifetime. The gear reducer is ideal for discontinuous use, working course s3-30%, with a maximum activation time of 25 minutes.
The Gear box reduction gear motor comes with an FT85 motor assembly flange, to which the right IEC standard motor can certainly be installed (EN 50347).
The Gear box has a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off at the end positions. The limit change system is installed within an included chamber and can be enclosed by an impact-resistant plastic-type cover. The limit change system is accessible and easy to adjust. The limit change system’s maximum switching range is usually 40 or 64 revolutions of the drive shaft. The cabling is connected in spring-clip connections. The gear reducer comes with an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.
The reducer for greenhouse includes 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates are available as accessories.
Maximum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in case of app of 4-pole electric motor.
Protection class IP65.
May be used in ambient temps of 0-60°C.
Suitable for discontinuous use, operating class s3-30%, optimum activation time 25 mins.
Equipped as regular with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installing IEC regular motor (EN 50347).
Maximum switching selection of limit switch system 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).